Chapter 38 IP Bridge
IES-1248-51V User’s Guide
288
38.5.1 Current Interfaces Screen
Use this screen to look at all the forwarding information for downstream traffic,
whether learned by snooping DHCP packets or provided manually.
To open this screen, click Advanced Application > IP Bridge > Downlink
Interface > Show Current Interfaces.
Figure 135 Current Interfaces
The following table describes the labels in this screen.
Table 91 Current Interfaces
LABEL DESCRIPTION
Refresh Click this to update the information in this screen.
Close Click this to close this window.
Index This field displays the index number of the downlink interface.
Interface IP
NetMask
This field displays the IP address and the number of bits in the subnet
mask that define the range of IP addresses to which this downlink
interface applies. If the destination IP address of a packet is in this
range, the IES-1248-51V tries to forward the frame to a subscriber in
the specified VLAN and PVC, if any.
VID This field displays the VLAN ID the subscriber is in.
Port This field displays the number of the ADSL port to which the IES-
1248-51V forwards frames. It displays “-” if the IES-1248-51V looks
for the subscriber in the whole VLAN and not a specific PVC.
VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit
Identifier (VCI), if any. The VPI and VCI identify a channel on this
port.
Type This field specifies whether the downlink interface is running on
Ethernet (ipoe) or on ATM (ipoa).
To Next Page
Loading...