ZyXEL Communications IES-1248-51A - DSCP Commands; Ethernet Commands

Chapter 60 Switch and Statistics Commands
IES-1248-51V User’s Guide
442
60.2 DSCP Commands
The following table describes the dscp commands. Use these commands to
configure the DiffServ Code Point settings of the IES-1248-51V’s ports.
60.3 Ethernet Commands
The following table describes the enet commands. Use these commands to
configure the settings of the IES-1248-51V’s Ethernet ports.
switch dot1x radius port
<port>
Sets the RADIUS server port. H/H
switch dot1x radius secret
<secret>
Sets the RADIUS server secret. H/H
switch dot1x radius show Displays RADIUS server settings. M/L
switch dot1x show [portlist] Displays IEEE 802.1x settings. M/L
statistics dot1x [portlist] Displays the IEEE 802.1x information for the
specified port(s).
M/L
Table 164 IEEE 802.1x Commands (continued)
COMMAND DESCRIPTION P
Table 165 DSCP Commands
COMMAND DESCRIPTION P
switch dscp disable <portlist> Disables DSCP mapping on the specified xDSL
or Ethernet port(s).
M/
H
switch dscp enable <portlist> Enables DSCP mapping on the specified xDSL
or Ethernet port(s).
M/
H
switch dscp map set <srccp>
<mappri>
Configures the DSCP-to-802.1p mapping
table.
srccp: source code point (0~63). For
example, 1,3~5,10~15).
mappri: mapping priority (0~7).
M/
H
switch dscp map show Displays the DSCP-to-802.1p mapping table. L/L
switch dscp show [portlist] Displays the DSCP setting for the specified
port(s).
L/L
Table 166 Enet Commands
COMMAND DESCRIPTION P
switch enet disable <portlist> Turns off the specified Ethernet port(s). H/H
switch enet enable <portlist> Turns on the specified Ethernet port(s). H/H