Chapter 66 Virtual Channel Commands
IES-1248-51V User’s Guide
519
them or the subscribers that use them). Use the following commands to define
channels.
66.3.1 PVC Set Command
The following example sets a PVC on ADSL port 1 with VPI 1, VCI 34, default VID
100 and priority 3. It sets the “platinum” profile for downstream traffic shaping
and a VC profile named “plus” for upstream traffic policing.
66.4 Priority-based PVCs
A PPVC (Priority-based PVC) allows you to give different priorities to PVCs that are
members of the same VLAN.
The IES-1248-51V uses eight priority queues (also called levels) for the member
PVCs. The system maps frames with certain IEEE 802.1p priorities to a PVC with a
particular priority queue. See Chapter 16 on page 119 for the factory default
mapping.
Table 196 PVC Commands
COMMAND DESCRIPTION P
adsl pvc show
[<portlist>[<vpi><vci>]]
Displays the Permanent Virtual Circuit (PVC) parameters of
the specified ADSL port(s) or all of the ADSL ports if you do
not specify any.
M/L
adsl pvc set
<portlist><vpi><vci><super|
vlanid<priority>><ds-
vcprofile[,us-vcprofile]>
Allows the configuration of a PVC (permanent virtual circuit)
for one or a range of ADSL ports.
super: Enable the super channel option to allow a channel
to forward frames belonging to multiple VLAN groups (that
are not assigned to other channels). The IES-1248-51V
forwards frames belonging to VLAN groups that are not
assigned to specific channels to the super channel. The
super channel functions in the same way as the channel in a
single channel environment. One port can have only one
super channel.
H/H
adsl pvc delete
[<portlist>[<vpi><vci>]]
Deletes the specified PVC channel. H/H
Figure 224 PVC Set Command Example
ras> adsl pvc set 1 1 34 100 3 platinum,plus
To Next Page
Loading...