IES-1248-51V User’s Guide
307
CHAPTER 43
Static Routing
This chapter shows you how to configure the static routing function.
Static routes tell the IES-1248-51V how to forward the IES-1248-51V’s own IP
traffic when you configure the TCP/IP parameters manually. This is generally
useful for allowing management of the device from a device with an IP address on
a different subnet from that of the device’s IP address (remote management).
To open this screen, click Routing Protocol > Static Routing.
Figure 143 Static Routing
The following table describes the labels in this screen.
Table 104 Static Routing
LABEL DESCRIPTION
Use this section to create a new static route.
Name Type a name to identify this static route. Use up to 31 ASCII
characters. Spaces and tabs are not allowed.
Destination IP
Address
This parameter specifies the IP network address of the final
destination. Routing is always based on network number. If you need
to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
To Next Page
Loading...