ZyXEL Communications IES-1248-51A - ARP Show Command Example; IP Settings and Default Gateway Example; Route Show Command Example

Chapter 61 IP Commands
IES-1248-51V User’s Guide
449
61.1.1 IP Settings and Default Gateway Example
The following command sequence sets the IES-1248-51V to have 192.168.1.3 as
the IP address, 255.255.255.0 for the subnet mask and 192.168.1.233 for the
default gateway.
The IES-1248-51V leaves the factory with a default management IP address of
192.168.1.1 and a subnet mask of 255.255.255.0, (ff:ff:ff:00 in hexadecimal
notation), and the default gateway set at 192.168.1.254. Make sure that you
configure the IP parameters correctly before you connect a IES-1248-51V to the
network, otherwise, you may interrupt services already running.
61.1.2 Route Show Command Example
This example displays the IES-1248-51V’s routing table.
61.1.3 ARP Show Command Example
Here is an example of the IES-1248-51V’s IP ARP table.
ras> ip set 192.168.1.3/24
ras> ip gateway 192.168.1.233
ras> config save
ras> ip route show
index dest interface gateway metric name
----- ------------------ --------- --------------- ------ ------------------
1 192.168.1.0/24 Ethernet 192.168.1.1 1
2 default voip VoIP 192.168.2.254 1
3 192.168.2.0/24 VoIP 192.168.2.1 1
4 default management Ethernet 192.168.1.254 1
ras> ip arp show
ip mac address
--------------- -----------------
192.168.2.254 00:0c:db:30:ac:00
192.168.15.254 00:0c:db:30:ac:00