ZyXEL Communications IES-1248-51A - Pppoe Intermediate Agent Enable Command Example

Chapter 54 DHCP Commands
IES-1248-51V User’s Guide
398
54.5.1 PPPoE Intermediate Agent Enable Command Example
The following example activates the PPPoE agent setting for VLAN 100.
switch poeagent disable
<vid|all>
This command removes the vendor-specific
tag from PADI and PADR packets for PPPoE
clients in the selected VLAN(s) or for all
VLANs.
H/H
switch poeagent info <vid|all>
<description>
This command specifies the extra information
the IES-1248-51V adds to PADI and PADR
packets in the specified VLAN or in all VLANs,
if the PPPoE intermediate agent is enabled.
Note: Before you can configure PPPoE
intermediate agent information, you
must first create a entry using the
poeagent set command.
description: The PPPoE line information
the switch is to add to PPPoE discover
packets from the specified VLAN or from all
VLANs. Enter a description (up to 23
alphanumerical characters).
H/H
switch poeagent set <vid> This command creates a PPPoE agent
information entry for the VLAN. After you
have created an entry for a VLAN, you can
configure the line information settings.
vid: VLAN ID.
H/H
switch poeagent show
[vlanlist]
This command displays PPPoE intermediate
agent settings for the specified VLAN or for
all VLANs.
vlanlist: You can specify a single VID (1),
all VIDs (*), a list of VIDs (1,3), or you can
also include a range of VIDs (1,5,6~10).
M/L
Table 144 PPPoE Intermediate Agent Commands (continued)
COMMAND DESCRIPTION P
ras> switch poeagent enable 100
ras> switch poeagent show
vid enable optionmode info
---- ------ ---------- -----------------------------
0 V private
100 V private
Note: vid 0 is the default agent.