Chapter 15 ENET Port Setup
IES-1248-51V User’s Guide
118
Speed Mode Select the type of Ethernet connection for this port. When you don’t
use auto-negotiation, you must make sure that the settings of the
peer Ethernet port are the same in order to connect.
Select Auto (auto-negotiation) to have the IES-1248-51V
automatically determine the type of connection that the Ethernet port
has. When the peer Ethernet device has auto-negotiation turned on,
the IES-1248-51V negotiates with the peer to determine the
connection speed. If the peer Ethernet port does not have auto-
negotiation turned on, the IES-1248-51V determines the connection
speed by detecting the signal on the cable and using full duplex.
When an Ethernet port is set to Auto, the IES-1248-51V tries to
make a fiber connection first and does not attempt to use the RJ-45
port if the fiber connection is successful.
Select 100 Copper if the Ethernet port has a 100 MB electrical
connection.
Select 1000 Copper if the Ethernet port has a 1000 MB (1 gigabit)
electrical connection.
Select 1000 Fiber if the Ethernet port has a 1000 MB (1 gigabit) fiber
optic connection.
Duplex The IES-1248-51V uses full duplex Ethernet connections.
Apply Click Apply to save your changes to the IES-1248-51V’s volatile
memory. The IES-1248-51V loses these changes if it is turned off or
loses power, so use the Config Save link on the navigation panel to
save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 18 ENET Port Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...