Chapter 17 xDSL Profiles Setup
IES-1248-51V User’s Guide
150
Fast Rate Down
(bps)
Specify a rate in kilobits per second (kbps). If a fast mode
connection’s downstream transmission rate decreases by more than
this number, then a trap is sent.
Interleave Rate
Up (bps)
Specify a rate in kilobits per second (kbps). If an interleave mode
connection’s upstream transmission rate increases by more than this
number, then a trap is sent.
Interleave Rate
Down (bps)
Specify a rate in kilobits per second (kbps). If an interleave mode
connection’s upstream transmission rate decreases by more than this
number, then a trap is sent.
Alarm profiles
with xDSL port
mapping
After you add an alarm profile, you can click a port number’s “-“
symbol to map the xDSL port to that alarm profile. The port’s “V”
symbol in the alarm profile where it was previously mapped changes
to “-“.
Modify Click Modify to edit a profile.
Delete Click Delete to remove a profile.
Table 28 Alarm Profile (continued)
LABEL DESCRIPTION
To Next Page
Loading...