Chapter 63 SNMP Commands
IES-1248-51V User’s Guide
468
sys snmp trapdst set <index>
<ip-address> [<port>]
Specifies the IP address (and port number) of a trap
server to which the IES-1248-51V sends SNMP traps. If
you leave the trap destination set to 0.0.0.0 (default), the
IES-1248-51V will not send any SNMP traps.
index: The number of the trap server (1~4).
port: The port number upon which the trap server listens
for SNMP traps. The IES-1248-51V uses the default of 162
if you do not specify a trap port.
H/H
sys snmp trapdst del <index> Removes the specified SNMP trap server setting. H/H
sys snmp show Displays the current SNMP get community, set community,
trap community, trusted hosts and trap destination
settings.
M/L
Table 182 SNMP Commands
COMMAND DESCRIPTION P
To Next Page
Loading...