3D Systems ProX DMP320 - Tip over Warning Label - Process Chamber Door; Burn Hazard Label - Back of Process Chamber. Adjacent to Oxygen Sensor

83 pages

To Next Page

To Previous Page

193D SYSTEMS, INC.

Tip Over Warning Label - Process Chamber Door

Burn Hazard Label - Back of Process Chamber. Adjacent to Oxygen Sensor.

Main Page

Default Chapter2
- Table of Contents2
Introduction5
Safety Guidelines and Instructions6
General Guidelines6
- Training and Instructions6
- Machine Handling6
- Material Handling6
- Laser6
- Alarms and Warnings6
Safety Symbols and Definitions7
First Aid Section- What to Do8
- Burns8
- Reporting Laser Radiation Exposure8
- Electrocution8
- Material Inhalation8
- Powder Ingestion8
- Powder Skin Contact8
- Powder Eye Contact8
- Safety Interlocks9
DMP Equipment Safety Features9
- DMP System Response if an Interlock Fails9
- Limited Access and Barrier Shielding10
- Other Active Safety Features10
Electrical Safety10
Personal Protective Equipment11
Hand Tools11
Grounding11
Vacuum Cleaners12
Fire and Explosion Prevention12
Room Ventilation12
Material Safety12
- Material Ignition Information12
- Finding Material Safety Information13
- Material Safety Information13
Potentially Hazardous Metal Powders14
Reactive Metal Powder Storage14
- Material Handling Precautions14
- Safe Material Handling Guidelines15
Argon Safety16
- Oxygen Deprivation Effects and Symptoms16
- Laser Safety17
- Laser Safety Classifications17
- Biological Risk17
Risk Relating to Gas Bottles17
Risk Relating to Liquid Argon Gas Containers17
Chemical Risk17
- Safety Labels on the DMP System18
- European Directives22
  - European Directive 89/686/CE in Europe22
  - Operator Safety22
System Specifications22
Prox Dmp320 at a Glance23
Software Overview28
- DMP Explorer28
- DMP Control30
- DMP Deposition41
System Use49
- Powering up Prox DMP 32049
- Shutting Printer down50
- Preparing Prox DMP 32051
- Removing Printed Parts from Printer59
- Purging Used Material62
Sieving Station (Optional)64
- Operation64
- Sieving System Maintenance66
Maintenance69
- Material Change: Changing Powder in a Build Module71
- Clean Laser Window72
- Door Seal and Door Bolts74
- Door Seal Removal and Replace74
- Clean Overpressure Valve75
- Chiller Fluid Replacement75
- Cleaning the Chiller Air Vent and Changing the Air Vent Filter76
- Drain Filter Replacement76
Troubleshooting77
- Client Software (DMP Control, DMP Explorer77
- Reinstall or Restore a Broken DMP Server Computer78
- DMP Explorer79
- DMP Deposition82

3D Systems ProX DMP320 - Tip over Warning Label - Process Chamber Door; Burn Hazard Label - Back of Process Chamber. Adjacent to Oxygen Sensor

Table of Contents

Related product manuals