3D Systems ProX DMP320 User Manual

643D SYSTEMS, INC.
7
SIEVING STATION (OPTIONAL)
The sieving station allows the user to automatically sifts material
from the overow bins and separate it into the waste and the usable
material that can be fed into the feeds to new build parts.
Operation
1. Carefully pour material from the overow reservoirs into the top of
the sieving station (1).
2. Close the lid (2).
3. Make sure the main switch is on, the emergency button is not
engaged and the reset button is not lighting up. If the reset button
lights up, press it to reset the safety.
4. Press the green start button (3).
5. Set the timer. The timer can be set between 0 and 10 hrs
depending on the amount of powder to be sieved.
1
2
Powder intake container (1)
Cyclone sieving chamber (2)
Container with waste powder (3)
Container with re-usable powder (4)
Oxygen sensor (5)
Main power switch (6)
Control panel with emergency switch (7)
1
2
3
4
6
3
4
5
7

3D Systems ProX DMP320 Specifications

General

Brand	3D Systems
Model	ProX DMP320
Category	3D Printers
Language	English