3D Systems ProX DMP320 - Actuators; Sensors; Machine Preparation Checklist

83 pages

To Next Page

To Previous Page

443D SYSTEMS, INC.

Actuators

By pressing the button on the right this screen opens up and shows all currently engaged actuators

Sensors

By pressing the button on the right this screen opens up and shows all current sensor data

Machine preparation checklist

When you press the “prepare for job start” button the following checklist

pop’s up:

Main Page

Default Chapter2
- Table of Contents2
Introduction5
Safety Guidelines and Instructions6
General Guidelines6
- Training and Instructions6
- Machine Handling6
- Material Handling6
- Laser6
- Alarms and Warnings6
Safety Symbols and Definitions7
First Aid Section- What to Do8
- Burns8
- Reporting Laser Radiation Exposure8
- Electrocution8
- Material Inhalation8
- Powder Ingestion8
- Powder Skin Contact8
- Powder Eye Contact8
- Safety Interlocks9
DMP Equipment Safety Features9
- DMP System Response if an Interlock Fails9
- Limited Access and Barrier Shielding10
- Other Active Safety Features10
Electrical Safety10
Personal Protective Equipment11
Hand Tools11
Grounding11
Vacuum Cleaners12
Fire and Explosion Prevention12
Room Ventilation12
Material Safety12
- Material Ignition Information12
- Finding Material Safety Information13
- Material Safety Information13
Potentially Hazardous Metal Powders14
Reactive Metal Powder Storage14
- Material Handling Precautions14
- Safe Material Handling Guidelines15
Argon Safety16
- Oxygen Deprivation Effects and Symptoms16
- Laser Safety17
- Laser Safety Classifications17
- Biological Risk17
Risk Relating to Gas Bottles17
Risk Relating to Liquid Argon Gas Containers17
Chemical Risk17
- Safety Labels on the DMP System18
- European Directives22
  - European Directive 89/686/CE in Europe22
  - Operator Safety22
System Specifications22
Prox Dmp320 at a Glance23
Software Overview28
- DMP Explorer28
- DMP Control30
- DMP Deposition41
System Use49
- Powering up Prox DMP 32049
- Shutting Printer down50
- Preparing Prox DMP 32051
- Removing Printed Parts from Printer59
- Purging Used Material62
Sieving Station (Optional)64
- Operation64
- Sieving System Maintenance66
Maintenance69
- Material Change: Changing Powder in a Build Module71
- Clean Laser Window72
- Door Seal and Door Bolts74
- Door Seal Removal and Replace74
- Clean Overpressure Valve75
- Chiller Fluid Replacement75
- Cleaning the Chiller Air Vent and Changing the Air Vent Filter76
- Drain Filter Replacement76
Troubleshooting77
- Client Software (DMP Control, DMP Explorer77
- Reinstall or Restore a Broken DMP Server Computer78
- DMP Explorer79
- DMP Deposition82

3D Systems ProX DMP320 - Actuators; Sensors; Machine Preparation Checklist

Table of Contents

Related product manuals