Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 111
Time Measurement
The Time Measurement block measures the time that the input Signal has been
active. The block measures time with a resolution of one second. The elapsed time
is presented on the display in the form
hours : minutes : seconds.
The internal counter can be reset to zero by selecting Reset and pressing the OK
key.
When the block is active and selected from the Operator Option List the time is
shown on the controller display as below.
Figure 43 Time Measurement Display.
Table 73 Time Measurement Inputs.
Table 74 Time Measurement Parameters.
Inputs
Name Connection
Signal Off, Digital
Parameters
Name Setting Unit
Reset OK None
Available in
ECA06 ECA60 ECA600 EMA60
--XX
Signal
Time
Measurement
FO1: Elapsed time
hhhh:mm:ss
To Next Page
Loading...
