A.1 Level Control with Feed Forward and Gain Scheduling Appendix A: Application Examples
212 493-0736-11 (6-2)
• One analogue input from the flow transmitter.
• One analogue output to control the valve (Control Output).
For the level transmitter choose AI1 (as in the Default Configuration) and for LV1
choose AO1 (as in the Default Configuration). For the flow transmitter choose
AI2.
Electrical Installation
Power Wiring
For details of the power installation please refer to chapter 2 of this manual.
Signal Wiring
Connect the transmitter and I/P converter to the controller unit according to the
figure below, using screened cable.
To Next Page
Loading...
