Chapter 2: Installation 2.1 Panel Cutout
493-0736-11 (6-2) 17
Chapter 2
Installation
This chapter provides all the information required by trained service engineers to
install the ECA06, ECA60, ECA600 and EMA60 controllers and to make all the
necessary electrical connections.
The ECA06, ECA60, ECA600 and EMA60 controller units fit into a cutout in a
vertical panel which allows high packing density. The panel must be between
2 mm and 4 mm thick. For installation on thicker panels, contact your local
representative.
Warning – Damage From ESD: To reduce the risk of damage to the controller
from ESD (electrostatic discharge) you should discharge yourself by touching a
suitable ground point before handling the controller.
2.1 Panel Cutout
The dimensions and spacing of the panel cutouts required for installation of the
controller are shown below. All dimensions are in mm.
Note: The panel may need extra support if a large number of controllers are
mounted on it and the minimum spacing between the panel cutouts is used.
To Next Page
Loading...
