Chapter 2: Installation 2.3 Installation with Mounting Plates and IP65 Gasket
493-0736-11 (6-2) 23
2.3 Installation with Mounting Plates and IP65
Gasket
To install the unit with mounting plates you need two mounting plates and four
fixing nuts as shown in the figure below. For IP65 compliance you also need the
gasket.
Figure 7 Mounting Plates, Fixing Nuts and IP65 Gasket.
Installation
To install the controller with the mounting plates and IP65 gasket proceed as
follows:
1 Remove the two mounting plates from the controller unit by removing the
four fixing nuts at the rear of the controller.
2 If you require IP65 sealing, mount the IP65 gasket by rolling it forward from
the rear of the controller to the front frame. Check that the gasket is correctly
installed in groove at the front of the frame.
3 Insert the controller into the panel cutout from the front.
4 Remount the mounting plates and secure in place by tightening the four nuts
at the rear of the controller.
To Next Page
Loading...
