Chapter 3: Configuration 3.3 Entering Configuration Mode
493-0736-11 (6-2) 53
3.3 Entering Configuration Mode
No Password Configured
To enter Configuration Mode if no password has been configured:
1 Press and hold the Next key.
2 When the display changes to show that Configuration Mode has been
entered release the Next key.
When the controller enters the Configuration mode the display shows the
following:
Figure 29 Configuration Mode Start-up Display.
Where:
XXX = Software type (06 for ECA06, 60 for ECA60, 600 for ECA600 and MI
for EMA60).
ZZZ.ZZ-ZZ = Software Version e.g. 001.05-00.
Password Configured
To enter Configuration Mode if a password has been configured:
1 Press and hold the Next key.
2 You are prompted to enter the password. This is a number in the range
1–9999.
Figure 30 Password Prompt.
Config XXX ZZZ.ZZ.ZZ
Inputs
Return
OK
Config 600 001.05-00
Enter Code
0
Cancel
OK
To Next Page
Loading...
