ABB ECA06 - EMA60 Operator Block

3.6 Setting the Configuration Chapter 3: Configuration
190 493-0736-11 (6-2)
Figure 63 Segments Lit in Point Mode (Left) and Reversed Point Modes (Right).
EMA60 Operator Block
The Operator Block (OP) handles the presentation of all information on the
controller front panel.
The Operator block in EMA60 has three analog inputs: Signal1 is indicated on the
left bar graph (PV), Signal2 is indicated on the center bar graph (SP) and Signal3
is indicated on the right bar graph (OUT).
Available in
ECA06 ECA60 ECA600 EMA60
---X
Signal1
EMA60
Operator
Signal2
Signal3