Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 193
Table 146 EMA60 Operator Block Parameters.
Note: The “x” character in the BargraphMode and BargraphAlarm parameters
represents “Left”, “Center” or “Right”.
System Block
The System Block (SY) monitors the controller communications and status.
Status
The status block has one digital input, ComputerModeEnable and two digital
outputs, ComputerMode and ErrOrWarn. The block does not hold any user
definable parameters. ComputerMode can be set to give Local or Computer
control. For details of ErrOrWarn please refer to Appendix B Error, Warning and
Information Messages.
Table 147 System Status Input
HandKey Normal, LockInManual None
Inputs
Name Connection Default
Computer Mode Enable Off, Digital Off
Parameters
Name Setting Unit
Available in
ECA06 ECA60 ECA600 EMA60
XXXX
System
Block
Computer
Mode
Enable
ErrOrWarn
Computer Mode
To Next Page
Loading...
