3.6 Setting the Configuration Chapter 3: Configuration
192 493-0736-11 (6-2)
Bar Graphs
Each bar graph displays the corresponding input value. Alarm indicators can also
be shown on the bar graphs. The parameter BargraphAlarm determines which
alarm indication is presented on the bar graph. This is selectable from the
available Absolute Alarms and Deviation Alarms.
The parameter BarGraphMode allows you to select the same modes for each bar
graph as described for the ECA controllers.
Hand Key
On the EMA60 it is possible to lock the Hand key so that the control mode is
always manual by means of the parameter HandKey.
Parameters
Name Setting Unit
xBarGraph
Mode
Bar, ReversedBar, Point, ReversedPoint None
NumberOf
Decimals
0 ≤ NumberOfDecimals ≤ 4None
MinValue –99999 ≤ MinValue ≤ MaxValue ≤ 99999 None
MaxValue –99999 ≤ MinValue ≤ MaxValue ≤ 99999 None
Unit %, °C, °F, K, W, kW, MW, J, kJ, MJ, rpm, Pa,
kPa, MPa, bar, mbar, bara, l, l/s, l/min, l/h, Psi,
Psig, Psia, mmWG, ”WG, mmvp, mvp, mmH
2
O,
mmHg, ”Hg, kp/cm
2
, N/m
2
, kg/cm
2
, kg/h, t/h,
Nm
3
/h, m
3
/h, t/24h, m/s, m/min, µs, µs/cm,
ppm, pH, mg/l, feet, inches, meters, tons, lbs,
lbs/sec, lbs/min, lbs/hr, ft/sec, ft/hr, BTU/hr,
BTU, ft
3
/sec, ft
3
/hr, gals, gal/sec, gal/hr, cu.ft,
MPPH, cc, cm, GPM.
None
xBarGraph
Alarm
off, AbsoluteAlarm1, AbsoluteAlarm2,
AbsoluteAlarm3, DeviationAlarm1,
DeviationAlarm2, DeviationAlarm3
None
Tag Text None
To Next Page
Loading...
