3.2 Controls and Indicators Chapter 3: Configuration
50 493-0736-11 (6-2)
LCD Display
In Configuration Mode the display consists of four lines of text, each consisting
of a maximum of 20 characters.
Figure 27 Typical Configuration Mode Display.
• The top line of the display shows the previous selection or current block.
• The second line shows the current selection or current parameter.
• The third line is blank until you start to change a parameter. The third line then
shows the current value of the parameter and changes as the Up/Down keys are
pressed. When the parameter is at the required value, press the OK key to store
the value. The third line is then blank again.
• The bottom line describes the present functions of the Cancel, OK and Next
keys. Each key function is labelled in inverse text above the key. If the key has
no function at this particular level of the Configuration tree, the space above it
on the display is blank.
PV Bar Graph Display
The PV bar graph shows the Process Value. Any alarm levels which have been set
are shown as brighter segments.
SP Bar Graph Display
The SP bar graph shows the Set Point value. Any configured Set Point limits are
shown as brighter segments.
Process Value
Unit
rpm
Cancel
OK
To Next Page
Loading...
