3.7 Status Signals Chapter 3: Configuration
198 493-0736-11 (6-2)
3.7 Status Signals
The various status signals and their locations within the controller are listed in the
table below.
Table 154 Status Signal Locations.
3.8 Test Mode
To enter Test Mode press the OK key for a few seconds.
In Test mode, you can select from a list of choices using the Next key:
• Display test (Display and bar graph test. All pixels and LEDs are lit).
• Working Time (Time elapsed since power up. Days, hours, minutes, seconds).
In the example below, the unit has been powered up for 76 days, 14 hours,
32 minutes and 10 seconds.
Figure 65 Working Time Example.
To exit Test mode press the Cancel key. The unit returns to Operator mode.
Status Signal Block Location
Ramp Set Point Block
Absolute Alarms Absolute Alarm Block
Deviation Alarms Deviation Alarm Block
Computer/Local Mode System Block
ErrorOrWarningActive System Block
Control Mode Output Configuration Block
Working Time
76d 14:32:10
To Next Page
Loading...
