5.10 Mains Supply Chapter 5: Technical Data
206 493-0736-11 (6-2)
• Bar graph also shows actuator position with increase/decrease output.
Alarms
• Flashing segment on bar graph and message on display.
Set Point Indication
• Digital Set Point value indicated on the display.
Cascade Control (Internal)
• Slave controller indicated by S in the display.
• Master controller indicated by M in the display.
Function Keys
• Fixed function keys in Normal operating mode, variable function keys in
Configuration Mode.
• Manual On/Off key includes a red light emitting diode to indicate manual
control is On.
Configuration
• Position in the Configuration tree and parameter values indicated on the
display.
5.10 Mains Supply
A.C.
• 110 V, 120 V, 220 V or 240 V a.c. ±10 %, 50/60 Hz.
• Power consumption 17 VA maximum.
D.C.
•24V d.c. ± 10 %
• Power consumption 10 W maximum.
• Reverse polarity protection via rectifier (refer to on page 27).
• It is possible to supply the controller with 19 V a.c. rms via d.c. terminals (z4
and z6).
• D.C. supply should be fused appropriately.
To Next Page
Loading...
