3.6 Setting the Configuration Chapter 3: Configuration
116 493-0736-11 (6-2)
Set Point Block
The Set Point block (SP) processes the Set Point data. The Control Block is
permanently connected to the Set Point block.
Notes:
• The ECA600 contains two Control blocks and therefore has two Set Point
blocks.
• The EMA60 Set Point block does not have an ESPEnable input, an ESPSignal
and associated parameters, an ESPMode output or a Simple Set Point Ramp.
Available in
ECA06 ECA60 ECA600 EMA60
XXXX
PVSignal
ESPSignal
ESPEnable
ECA
Controllers
Set Point
PVValue
SPValue
RampDone
RampActive
ESPMode
RampHold
PVSignal
EMA60
Set Point
PVValue
RampDone
RampActive
RampHold
SP Value
To Next Page
Loading...
