Chapter 3: Configuration 3.1 Configuring the Process Value
493-0736-11 (6-2) 43
Chapter 3
Configuration
This chapter is intended for trained personnel such as Process Control Engineers
or Instrument Technicians who configure the ECA06, ECA60, ECA600 and
EMA60 controllers. It describes the operator interfaces and features available in
the Configuration Mode and includes full instructions for the configuration of the
controllers.
When configurating, the regulator must be in Manual mode (ECA600 both loops),
in order to change the parameters.
In this mode, neither the operator nor the controller can change the output signal.
3.1 Configuring the Process Value
One of the first things any user will want to do is configure the Process Value –
this section shows you how to do this.
Note: To select the display language refer to the section Display Language on
page 197.
To Next Page
Loading...
