ABB ECA06 - Error and Warning Descriptions; FLASH Write; FLASH Erase; FLASH Checksum

Appendix B: Error, Warning and Information Messages B.4 Error and Warning Descriptions
493-0736-11 (6-2) 241
1 Make sure you are in Operator Mode.
2 Access the Message List by multiple pressing of the Next key.
3 Acknowledge the Error or Warning by pressing the OK key.
Figure 10 Display – Acknowledging a Message.
B.4 Error and Warning Descriptions
HW
If the system detects a hardware (HW) error, this error is set. If the signal wires of
an analog input are connected with reverse polarity, the following actions should
be taken:
1 Turn off power of controller unit
2 Install wires properly
3 Turn on power of controller unit again
FLASH Write
If a Write Error occurs in the FLASH memory, this error is set.
FLASH Erase
If an Erase Error occurs in the FLASH memory, this error is set.
FLASH Checksum
If a Checksum Error occurs in the FLASH memory, this error is set.
RAM
If a Checksum Error is found in the Configuration RAM memory, this error is set.
To Ack press √
Acknowledge