ABB ECA06 - Page 118

3.6 Setting the Configuration Chapter 3: Configuration
118 493-0736-11 (6-2)
Table 83 Set Point Block Outputs
Process Value
PVSignal should be connected to the process value. This is usually an Analog
Input block (AI), but can also be a Function block (FA, FO) or an Analog Input
Communication Buffer block (AIC).
Set Point
There are two different Set Points:
• ISP – Internal Set point (set via the front panel).
• ESP – External Set Point (block input).
The Set Point Block has two analog inputs, PVSignal and ESPSignal *, and one
digital input, ESPEnable*. The block has two analog outputs, PVValue and
SPValue and four digital outputs, RampDone, RampActive, ESPMode* and
RampHold.
Outputs
Name Type
PVValue 0 ≤ PVValue ≤ 100
SPValue 0 ≤ SPValue ≤ 100
ESPMode * Digital
RampDone Digital
RampActive Digital
RampHold Digital