3.6 Setting the Configuration Chapter 3: Configuration
126 493-0736-11 (6-2)
Figure 47 Simple Set Point Ramp Timing and Function Example.
At t = 1 the control Mode changes from non Auto (Manual, Tracking, or Forced
Output) to Auto and the ramp starts.
In the example above with TimerTime = 2.
The time 5 – (minus) 4 < TimerTime and therefore the ramp is not complete.
Time
SPValue
AutoStatus Input
RampActive Output
RampDone
Internal Timer Active
100
90
80
70
60
50
40
30
20
10
0
024681012
To Next Page
Loading...
