ABB ECA06 - Page 57

Chapter 3: Configuration 3.6 Setting the Configuration
493-0736-11 (6-2) 57
The key sequence to set this parameter is given in full below but can be
abbreviated to the form:
Outputs → Analog Outputs → AO1 → Mode = Reversed
To configure the mode parameter proceed as follows:
1 Access the Configuration Menu as described in section 3.3.
2 Press the Up or Down key until the second line of the display shows Outputs.
3 Press the OK key.
4 Press the Up or Down key until the second line of the display shows Analog
Outputs.
5 Press the OK key.
6 Press the Up or Down key until the second line of the display shows AO1.
7 Press the OK key.
8 Press the Up or Down key until the second line of the display shows Mode.
Config 600 001.05-00
Outputs
Return
OK
Outputs
Analog Outputs
Return
OK
Analog Outputs
AO1
Return
OK