3 Maintenance
3.5.1. Gearboxes, axes 1- 4
1033HAC030005-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
12. Refit the Magnetic Plug
(A), change the sealing
washers if necessary.
Tightening Torque 10-12 Nm.
13. The oil is filled through
the plug holes (A) with
specified volume,
check oil level by
removing the oil level
plug (B).
Specified volume see Oil and Grease specification on page
199.
xx0700000729
14. Refit the transmission
cover using the 6pcs
M6 x 20 Hexagon bolt
with flange.
Use Locking liquid
(Loctite 243).
On WD. and WDS.
apply a 5mm string of
Sikaflex on the sealing,
after tightening remove
superfluous Sikaflex.
NOTE!
Follow the Tightening
sequence in the figure.
xx0800000024
Tightening Torque 4 Nm.
15. Refit the 3 pcs flange
and the 3 pcs flange
gasket, using the 6 pcs
M6x20. Apply Locking
liquid (Loctite 243).
(Change the gaskets if
necessary.)
Tightening Torque 4 Nm.
Action Note
Continued
Continues on next page
To Next Page
Loading...
