7 Reference information
7.7. Special tools
1973HAC030005-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
7.7. Special tools
General
All service instructions contain lists of tools required to perform the specified activity. The
required tools are a sum of standard tools, defined in section Standard toolkit on page 196,
and of special tools, listed directly in the instructions and also gathered in this section.
Special tools IRB360
The table below specifies the special tools required during service procedures. The tools are
also specified directly in concerned procedures for repair.
Item Description Art.no. Note
A Drifter for mounting wear
rings.
3HAC4184-1
B Dolly for joint socket when
inserting new wear rings.
3HAC4182-1
C Pliers for Parallel Arms 3HAC6194-1
To Next Page
Loading...
