3 Maintenance
3.3.2. Telescopic Shaft, Wash Down, Axis 4
3HAC030005-001 Revision: -78
© Copyright 2006 ABB. All rights reserved.
3.3.2. Telescopic Shaft, Wash Down, Axis 4
General
This section describes maintenance on the Telescopic Shaft (Wash Down), Axis 4 interval
500 and 4000 h
DANGER!
Turn off all electrical power, hydraulic and pneumatic pressure supplies to the robot!
Also read the safety sections:
• Safety risks related to pneumatic/hydraulic systems on page 18
• Risks associated with live electric parts on page 20
• Safety risks during installation and service work on robot on page 15
NOTE!
The wear on the bearings depends on the payload, cycle, environment, and lubrication.
Telescopic Shaft
xx0700000717
Required Equipment and References
References
Replacement of Telescopic Shaft on page 133
Spare Parts, Telescopic shafts on page 220.
Continues on next page
To Next Page
Loading...
Need help?
General