3 Maintenance
3.3.2. Telescopic Shaft, Wash Down, Axis 4
793HAC030005-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
Interval 500 h
Interval 4000 h
Action Note
1. Check and retighten set screws.
2. If the linear bushings are worn out or if the backlash
is excessive, change the Telescopic Shaft and the
Universal Joints.
Described in section
Replacement of Telescopic Shaft
on page 133.
Action Note
1. Change the Telescopic Shaft and the Universal
Joints.
Spare Parts, Telescopic shafts on
page 220
Continued
To Next Page
Loading...
