5 Calibration information
5.6. Calibration IRB 360 axis 4
1793HAC030005-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
5.6. Calibration IRB 360 axis 4
General
This section is valid for IRB 360 all models. It details how to perform the actual fine
calibration of axis 4.
Location
xx0700000629
Required equipment and references
Calibration steps
A Syncmark ax 4
Equipment Note
FlexPendant
References
Fine calibration procedure on FlexPendant on page 181
Checking the calibration position on page 187
Action Note
1. In manual mode, Tap Jogging in the
ABB menu.
Continues on next page
To Next Page
Loading...
