7 Reference information
7.6. Standard toolkit
3HAC030005-001 Revision: -196
© Copyright 2006 ABB. All rights reserved.
7.6. Standard toolkit
General
All service (repairs, maintenance and installation) procedures contain lists of tools required
to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools that are
considered standard are gathered in the Standard toolkit and defined in the table below.
This way, the tools required are the sum of the Standard Toolkit and any tools listed in the
instruction.
Contents, standard toolkit
Qty Tool
1 Ring-open-end spanner 7-35mm
1 Socket head cap 3, 5, 8 mm
1 Torque wrench 4-33 Nm
1 Small screwdriver
1 Plastic mallet
1 Ratchet head for torque wrench 1/2
1 Cut-off pliers
1 90° angled bit holder
Spirit level
To Next Page
Loading...
