4 Repair
4.3.15. Replacing of calibration marks
1573HAC030005-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
Required Equipment and References
Remove
Refitting
Equipment Spare Part No. Note
Standard tools Standard toolkit on page 196.
Calibration mark Spare parts in the base on
page 214
Action Note
1. Remove the two M5 nuts. Use standard tools.
2. Remove the calibration mark.
Action Note
1. Refit a new calibration mark.
2. Refit the two M5 nuts. Tightening torque 4Nm.
Continued
To Next Page
Loading...
