4 Repair
4.5.2. Replacement of Brake Release Button
1693HAC030005-001 Revision: -
© Copyright 2006 ABB. All rights reserved.
Refitting
Action Note
1. Remove the base cover. Replacement of base cover gasket on page 116.
CAUTION!
The base cover has sharp edges, use protective
gloves.
2. Remove the contact (A) from
the push button, pushing in the
locking device (C) in figure.
TIP!
Use a screw driver to push in the locking device.
3. Loosen the plastic nut and
remove the push button from
the transmission cover.
Use standard tools.
Action Note
1. Refit the push button to the
transmission cover using the
plastic nut (A).
NOTE!
Make sure to mount the
button cover or the robot will
not fulfill the IP67 classifica-
tion.
xx0700000651
A
Continued
Continues on next page
To Next Page
Loading...
