NoteAction
xx1200000860
Valid for Type C.
Remove the bracket securing the cable
package inside the base on the left side, by
following these steps:
• Unscrew the attachment screws just
enough to be able to remove the
bracket.
• Lift the bracket off the screws.
16
Parts:
• A: Base
• B: Attachment screws
• C: Bracket
xx0900000018
Valid for Other design than Type C.
Remove the bracket securing the cable
package inside the base on the left side, by
following these steps:
• Unscrew the attachment screws just
enough to be able to remove the
bracket.
• Lift the bracket off the screws.
17
Parts:
• A: Base
• B: Attachment screws
• C: Bracket
How to remove the cable package from
the frame is described in section
• Removing cable harness in frame
on page 203
Continue removal of the cable package from
the frame.
18
Continues on next page
202 3HAC033453-001 Revision: H
© Copyright 2009-2013 ABB. All rights reserved.
4 Repair
4.3.1 Removing the complete cable harness
Continued
To Next Page
Loading...
