3 Maintenance
3.3.1. Inspection, oil level gearbox axis 1
1233HAC026876-001 Revision: F
© Copyright 2007-2010 ABB. All rights reserved.
Inspection, oil level gearbox, axis 1
The procedure below details how to inspect the oil level in gearbox axis 1.
Action Note
1.
WARNING!
Handling gearbox oil involves several safety
risks. Before proceeding, please read the safety
information in the section WARNING - Safety
risks during work with gearbox lubricants (oil or
grease) on page 44.
2.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
For Foundry Prime robots:
Do not turn off the air pressure to motors and
SMB.
3. Open the filler plug. Shown in the figure Location of
gearbox on page 122.
4. Required oil level: max. 5 mm below the oil plug
hole.
5. Add oil if required. Art. no. is specified in Required
equipment on page 122.
Further information about how to fill
the oil may be found in the section
Filling oil, axis 1 on page 167.
6. Refit the oil plug, inspection. Tightening torque: 24 Nm.
Continued
To Next Page
Loading...
