4 Repair
4.5.2. Replacement of brake release unit
2893HAC026876-001 Revision: F
© Copyright 2007-2010 ABB. All rights reserved.
Removal, brake release unit
The procedure below details how to remove the brake release unit.
Action Note
1.
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot!
For Foundry Prime robots:
Do not turn off the air pressure to motors and
SMB.
2.
esd
WARNING!
The unit is sensitive to ESD. Before handling
the unit please read the safety information in
the section WARNING - The unit is sensitive
to ESD! on page 43
3. Remove the push button guard from the SMB
cover.
Shown in the figure Location of brake
release unit on page 288.
The guard must be removed to ensure a
correct refitting of the brake release unit.
4. Let the battery stay connected, to avoid the
need of synchronization of the robot!
Shown in the figure Location of brake
release unit on page 288.
5. Disconnect the connectors X8, X9 and X10
from the brake release unit.
xx0200000129
• A: Connector X8
• B: Connector X9
• C: Connector X10
• D: Push buttons
Location of the brake release unit is
shown in the figure Location of brake
release unit on page 288.
6. Remove the brake release unit from the
bracket by removing the four attachment
screws.
Continued
Continues on next page
To Next Page
Loading...
