4 Repair
4.5.8. Unloading the balancing device using hydraulic press tool.
3233HAC026876-001 Revision: F
© Copyright 2007-2010 ABB. All rights reserved.
Required equipment
Using the correct press device
The different designs of the balancing device require different versions of the press device,
included in the complete press tool. The table below specifies which press device to use to
which balancing device.
The article number of the balancing device may be found on a label at the rear of the balancing
device.
Unloading the balancing device
The procedure below details how to use the press tool in order to unload the balancing device.
How to remove the press tool, is detailed in section Restoring the balancing device using a
hydraulic press tool. on page 325.
Equipment, etc. Art. no. Note
Press tool, balancing device 3HAC020902-001 Includes
• press device 3HAC15767-2
• press device 3HAC18100-1
Choose the correct device, depending
on model of balancing device.
Hydraulic cylinder 3HAC11731-1 To be used with the press tool.
Hydraulic pump, 80 MPa 3HAC13086-1 To be used with the hydraulic cylinder.
Standard toolkit - The content is defined in the section
Standard toolkit on page 409.
Balancing device Press device
xx0700000475
Art. no: 3HAC18100-1
xx0300000599
Action Note
1. Fit the moving pin to the current press device. Choose the correct press device,
according to the table Using the correct
press device on page 323.
The moving pin is shown in the figure
Press tool and hydraulic cylinder on
page 322.
Continued
Continues on next page
To Next Page
Loading...
