2 Installation and commissioning
2.6.8. Installation of cooling fan for motors, axes 1 and 2 (option)
3HAC026876-001 Revision: F90
© Copyright 2007-2010 ABB. All rights reserved.
Required equipment
Equipment Art. no. Note
Cooling fan 3HAC15374-1
Cabling, cooling fans, axes
1 or 2.
3HAC023599-001 Choose this cabling if equipping the
robot with cooling fans on axis 1 or 2 .
Plate for customer
connections
3HAC025778-001 An additional connection plate must be
fitted to the robot base, if not already
installed. The plate is shown in the figure
Plate for customer connections, at base
on page 91.
Additional cabling to and
inside the controller
-
Material set fan axes 1 and
2
3HAC023999-001 The set includes:
• fan axes 1 & 2 cable harness
• plate, customer
• attachment screws and nuts.
Cable harness inside
controller
3HAC025488-001
Locking liquid - Loctite 243. Used for the three tightening
screws.
Standard toolkit - The content is defined in the section
Standard toolkit on page 409.
Circuit diagram -
3HAC025744-001
See the chapter Circuit diagram.
Other tools and procedures
may be required. See
references to these
procedures in the step-by-
step instructions below.
These procedures include references to
the tools required.
Continued
Continues on next page
To Next Page
Loading...
