ABB OmniCore V250XT - Page 256

Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V250XT via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
DSQC 6093HAC14178-1DSQC 609 power supply
DSQC 6343HAC13398-2DSQC 634 power supply
DSQC 6093HAC071467-001Harness PSU 24V
3HAB7983-1End clamp
DSQC 609 and DSQC 6343HAC071187-001Harness PSU
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 414.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC074000-008Circuit diagram - OmniCore
V250XT
Removing the DSQC 609 power supply
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Continues on next page
256 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.2.10 Replacing the power supply
Continued