Note/IllustrationAction
Insert the Ethernet outlet connector with
cable into the cover from inner side of
the cabinet.
3
xx2100000852
Secure it with the locking ring.4
Connect:
• X24 - A2.X3
5
Secure the Ethernet outlet connector with
cables with the clips on the cabinet.
Tip
Use the same position as from removing
the harness ETH outlet with cable.
6
Concluding procedure
Note/IllustrationAction
Closing the door on page 176.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 166.
2
332 Product manual - OmniCore V250XT
3HAC073447-001 Revision: B
© Copyright 2020-2022 ABB. All rights reserved.
5 Repair
5.3.5 Replacing the Ethernet outlet connector with cable
Continued
To Next Page
Loading...
