ABB | SACE Emax 2
182 | © 2013 ABB | 1SDH001000R0002 - L7804
Electronic accessories | 4 - Ekip Signalling 4K module
Continued from the previous page
The following table illustrates the path from the display for accessing information on the module:
Information
Protection unit
Circuit-breaker
Modules
…
Ekip Signalling 4K
…
Power Controller
The information on the module that can be displayed is as follows:
• The logical state of the inputs (“Off” if not active, “On” if active).
• The state of the output contacts (“Open” if open, “Closed” if closed).
The following tables illustrate the paths from the display to access the pages for programming
the actions you wish the release to perform in the event of an input being activated.
NOTE: the selection of an action opens a list of the programming parameters, that
is, a list of the events for which the action can be performed, and the delay. For details
on the parameters, see the chapter “19 - Operating features, and the paragraph "
Functional specifications, on page 148.
Advanced
…
Current thresholds
Function Trip RESET
Measurements
…
Frequency
Energy
(1)
Energy meters
Reset Meters
Energy RESET
Peak Factor
…
(1)
Menu available with Ekip Measuring or Ekip Measuring Pro modules.
Settings
Circuit-breaker
…
Earth protection
Function External Trip
Installation
Network frequency
Modules
…
Function
Switch On LOCAL
Signalling RESET
YO Command
YC Command
Power Controller
…
System
Function Switch On SET B
Maintenance
Continued from the previous page
To Next Page
Loading...
