142 Operating instruction SCK Gas Sampling System OI/SCK-EN Rev. E
Check the duct opening for clogging at regular intervals and clean if neces-
sary.
Note: Inserting the gas sampling probe when the duct opening is clogged can
lead to damage to the probe. The same applies to re-inserting the gas sam-
pling probe after prolonged standstill of the sampling system.
Owing to the greater flow speeds in this process, after start-up the gas sam-
pling probe must be checked frequently for wear at the calcinator gas outlet
measuring point. If distinct signs of wear are visible after a short time, check
the installation position of the gas sampling probe. Failing to observe this can
lead to severe damage or total loss of the gas sampling probe.
duct opening
calcinator gas outlet
To Next Page
Loading...
