ABB SCK - Chapter 9 Maintenance

OI/SCK
-EN Rev. E Operating instruction SCK Gas Sampling System 149
Chapter 9 Maintenance
Topic Page
Maintenance plan ............................................................................................... 150
Equipment layout plan ...................................................................................... 154
Acquiring spare parts and wear parts ............................................................ 157
Safety regulations for maintenance work ..................................................... 158
Operating the service switch ........................................................................... 161
Checking the condition of the system, cleaning the system ..................... 163
Evaluating trend displays ................................................................................. 166
Checking the residual current circuit breaker............................................... 167
Checking protective installations ................................................................... 169
Checking for leaks .............................................................................................. 173
Gas sampling probe H: Removing incrustations .......................................... 176
Gas sampling probe H: Replacing the intake filter ...................................... 178
Gas sampling probe H: Replacing membrane pump membranes ............ 181
Gas sampling probe 60S: Removing incrustations ...................................... 184
Gas sampling probe 60S: Cleaning or replacing the outlet filter .............. 186
Gas sampling probe 60S: Replacing the seal set ......................................... 189
Probe retractor: Checking filter/pressure control combination ............... 191
Probe retractor: Checking and replacing the filter muffler ........................ 193
Probe retractor: Checking and topping up the oiler .................................... 195
Probe retractor: Checking and tightening the drive chain ......................... 198
Probe retractor: Checking and, if necessary, adjusting the
position of the probe ....................................................................................... 200
Probe retractor: Checking and, if necessary, adjusting the
position indicator (probe end position) ....................................................... 204
Probe retractor: Checking the bellows ........................................................... 207
Cooling module: Vent the cooling-water circuit .......................................... 208
Cooling module: Checking and topping up cooling water ......................... 210
Pneumatic system: Replacing the compressed-air filter ............................ 213