ABB SCK User Manual

OI/SCK
-EN Rev. E Operating instruction SCK Gas Sampling System 91
Unpacking the system
Risk of injury in the area of the gas sampling system due to moving or fall-
ing parts, anti-freeze, lubricating oil
Wear general personal protective equipment:
 Closed overalls with long trousers and long sleeves
 Safety shoes
 Safety gloves suitable for mechanical work
 Safety glasses
 Protective helmet
 If necessary, additional protective equipment if prescribed by the opera-
tor.
Danger of crushing when lifting or lowering the transport unit
 Only appropriately trained personnel may transport the transport units and
only with the aid of the recommended transport equipment.
 Do not stand under suspended loads.
 Follow the transport instructions in these operating instructions care-
fully.
Perform the following steps to unpack the system:
Step
Procedure
1
Remove outer packaging:
 Transport crate
 Tensioning straps

Cardboard, films and wooden parts
2
Undo fasteners holding the system parts on the pallet.
3
Lift system parts off the pallet with a crane, fork-lift
truck or hand lift (observe transport recommendations
in Transporting the system in the company on page 89).
Note: The retractor must not be transported with a fork-
lift truck.
4
Dispose of packaging material in accordance with the
national regulations.
5
Transport system parts to the place of installation (see
Transporting the system in the company on page 89).
Mechanical and
material dangers
Heavy transport
units
Instructions

ABB SCK Specifications

General

Brand	ABB
Model	SCK
Category	Industrial Equipment
Language	English