ABB SCK - Safety Measures: Maintenance and Troubleshooting

80 Operating instruction SCK Gas Sampling System OI/SCK-EN Rev. E
Safety measures: Maintenance and troubleshooting
This section contains a summary of possible dangers during maintenance and
troubleshooting of the gas sampling system and measures designed to pre-
vent physical injuries.
Observe the following dangers and take the specified preventive action when
maintaining and troubleshooting the gas sampling system:
Danger
Where / in what situa-
tion does the danger
arise?
Preventive action
Mechanical, ther-
mal and material
dangers due to
moving or falling
parts, hot surfaces,
hot cooling water,
anti-freeze, com-
pressed air, lubri-
cating oil
During all work on the
gas sampling system
and in the vicinity of
the gas sampling sys-
tem
Wear general personal pro-
tective equipment:
 Closed overalls with long
trousers and long sleeves
 Safety shoes
 Safety gloves suitable for
mechanical work
 Safety glasses
 Protective helmet
 If necessary, additional
protective equipment if
prescribed by the opera-
tor.
Risk of crushing by
heavy transport
units
When lifting or lower-
ing transport units

Only appropriately
trained personnel may
transport the transport
units and only with the
aid of the recommended
transport equipment.
 Do not stand under sus-
pended loads.
 Follow the transport
instructions in these op-
erating instructions care-
fully.
Meaning
Dangers and
preventive action