-EN Rev. E Operating instruction SCK Gas Sampling System 241
Index
A
About these operating instructions • 6
Access permissions • 47
Acquiring spare parts and wear parts • 157
Activation • 118
After switching on
working on the cooling module • 121
Anti-freeze • 114
Appendix • 235
B
Basic safety rules • 54
C
Checking for leaks • 173
Checking general condition • 141
Checking protective installations • 169
Checking site conditions • 95
Checking the condition of the system, cleaning the
system • 163
Checking the pneumatic system • 123
Checking the residual current circuit breaker • 167
Checking/correcting operating parameters • 126
Checks to perform when using probe H • 127
Cleaning gas sampling probe 60S • 145
Cleaning gas sampling probe H • 143
Cleaning procedures
Probe 60S • 28, 145
Probe H • 26, 143
Compressed-air tank and pneumatic system • 33
Connecting external electric cables • 108
Connecting internal electric cables • 106
Connecting the sample gas line to the retractor •
105
Controls and displays • 22
Cooling module • 30
Checking and topping up cooling water • 210
Vent the cooling-water circuit • 208
D
Default operating parameter settings • 48
Description of control system • 35
Description of the sampling system • 15
Dimensions and weights • 16
Disassembling the system • 229
Disposal • 234
Disposing of the system • 234
E
Electrical connection plan • 238
Emergency Stop • 147
Equipment layout plan • 154
Error message display • 46
Errors • 215
Errors and irregularities • 216
Evaluating trend displays • 166
G
Gas sampling probe 60S • 28
Cleaning or replacing the outlet filter • 186
Removing incrustations • 184
Replacing the seal set • 189
Gas sampling probe H • 26
Removing incrustations • 176
Replacing membrane pump membranes • 181
Replacing the intake filter • 178
General • 5
General transport information • 86
H
Handling error messages • 223
I
Inserting the probe and switching to automatic
mode • 130
Installation • 93
Installation check • 113
Installing the compressed-air supply • 101
Installing the control cabinet • 100
Installing the cooling module • 103
Installing the cooling water circuit • 104
Installing the probe retractor • 97
Intended conditions of use • 17
To Next Page
Loading...
